| 

Worm Gear Speed Reducers

HDR Series

Worm Gear Speed Reducers & mounting bases | HDR Series

Worm Gear Speed Reducers & mounting bases

imagem meramente ilustrativa

1 ano de garantia
  • 8 Ratios Available from 5:1 to 60:1
  • 7 Gear Box Sizes from 1.33 to 3.25"
  • Universally Interchangeable Design for OEM Replacement
  • Double Bearings Used on Both Shaft Ends
  • Anti-Rust Primer Applied Inside and Outside Gearbox
  • Shaft Sleeve Protects All Shafts
  • S45C Carbon Steel Shafts
  • Flange Mount Models for 56C and 145TC Motors
Acionadores e Motores - Ver Produtos Relacionados

Descrição

The HDR Series worm gear reducers are used in low to moderate horsepower applications to reduce speeds and increase torque. Worm gear reducers are available in direct or indirect drive, direct drive models are 56C or 145TC flange mount with either right, left or dual output shafts or a hollow bore output. The indirect drive models are shaft input-shaft output boxes for use with sprocket or pulley drive systems. They provide an effective low cost solution to speed reduction and increased torque, with higher tolerances for shock loading than helical gear reducers.

In order to select a gearbox speed reducer, you will need to determine the required torque and service factor for the application. Click on "Specs" above for a table that will assist in determining the service factor. For service factors above 1.0, multiply the required torque by the service factor.

Use the Part Number Builder (below the ordering table) to find additional models

Manuais:

Baixar HDR Series - Installation-Maintainance Manual
Baixar HDR Series - Dimensional Drawings Specs
We noticed you are from the US. Visit your local site for regional offers and live support.