High Temperature Constant Wattage Heating Cable

KE Series

imagem meramente ilustrativa

Continuous Exposure Rating up to 500°F
Low Watt Density
Parallel Resistance Heater
Cut-to-Length at the Job Site
Constant Watt Density
All Common Voltages Available
Moisture and Chemical Resistance
Continuous Electrical Ground
Designed for freeze protection and process temperature maintenance.

Sistemas de Aquecimento Elétrico por Cabo - Ver Produtos Relacionados

Descrição

The KE Cable heating element is tension wrapped and covered with two layers of nonflammable Polyimide Film applied in reverse directions, then heat fused for moisture protection. A stainless steel and tinned copper sheath is then added for additional protection and electrical ground return path. The sheath is enclosed in a minimum 20 mil PFA abrasion and chemical resistant extruded jacket.

KE Cable is a low Watt density electrical resistance heater. It is designed for freeze protection, viscosity and high temperature process control in Class 1, Groups B, C, and D, Division 2 Classified Areas as well as in corrosive environments. KE is used in asphalt plants, oil refineries, mines, chemical and petrochemical processing areas, other locations where corrosive atmospheres can occur. KE is equally suitable for applications in severe arctic cold.

CAUTION AND WARNING!
Fire and electrical shock may result if products are used improperly or installed or used by non-qualified personnel. See inside back cover for additional warnings.

Max. Circuit Length**-KE Series

Power	120V	208V	240V	277V	480V
4 Watts/ft	349'	606'	699'	806'	1398'
8 Watts/ft	247'	428'	494'	570'	988'
12 Watts/ft	202'	350'	403'	466'	807'