SiNET™ Multi-Axis Motion Control

HUB 444

SiNET™ Multi-Axis Motion Control | HUB 444

SiNET™ Multi-Axis Motion Control

imagem meramente ilustrativa

1 ano de garantia
  • Networks Stepper Drives (1240i, 3540i, Si3540, ST series, STAC6 series, STM23 series) for Multi-Axis Motion Applications
  • Programmable with Easy-to-Use SiNet Hub Programmer™
  • 4 Optically Isolated Inputs, 5 to 24 Vdc
  • 4 Optically Isolated Outputs, 24 Vdc, 100 mA
  • Hub Programs and Host Computers Also Have Access to the I/O in Each Drive
  • Powered by Drive #1, No External Power Supply Required
  • Compatible with MMI-01 (Operator Terminal)
  • Communication via RS232
  • Sample Motion Programs Available by Request
Acionadores e Motores - Ver Produtos Relacionados


The SiNet™ Hub 444 allows up to 4 Stepper or Servo Si™ drives to be controlled in host mode from a single PC or PLC’s RS232 serial port or will run in stand-alone mode. Each indexer-drive acquires its unique address from the port to which it is connected. This simple addressing scheme minimizes the cost of the drives, and more importantly, the cost of configuring and/or replacing drives in your system. Connections are made with low cost, reliable RJ11 cabling. Any of our popular, cost effective programmable Stepper or Servo Si™ drives or Si™ motor controls can be used with the SiNet™ Hub 444. By choosing the power level and features you need for each axis of your application, SiNet™ can provide a cost effective single or multi-axis motion solution. The SiNet™ Hub 444 is powered by the drive that’s connected to port #1, saving you the cost and installation expense of using a separate power supply. Our Si Command Language™ (SCL) allows a host PC or PLC to execute relative, absolute and homing moves, make status inquiries, sample inputs, set outputs, and more. If your application requires a single axis to operate in "host mode", you can connect any of our programmable Si™ drives directly to your PC via the SiNet™ Hub 444 and invoke the Si Command Language™ (SCL). SCL allows for control via serial commands sent from a host device such as a PC or PLC. This permits the user to perform a variety of motion, I/O, and system status tasks in real time via a host serial device.

Our SiNet Programmer™ Windows software allows the user to create and store multi-axis motion control programs in the SiNet™ Hub 444 and run them without a PC, thus allowing the user to create a complex multi-axis motion system controlled from an operator interface or trigger.


Baixar HUB444 - Motion Control Network Hub
Baixar STM, ST, Stac6, 1240i, 3540i, si3540 Series - Si Command Language (SCL) for Stepper Drives
We noticed you are from the US. Visit your local site for regional offers and live support.